41603 Feature Control KEY: Duplicate dongle detected Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Thermoflex Think_Motion_Controller The firmware has detected that there is more than one dongle device connected to the dongle port. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. The firmware tried to determine the dongle serial number, but more than one dongle was detected attached to the dongle bus. This ambiguity prevents the device from detecting the correct dongle. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:35 2008 PST